A follow up for this. After the feedback, I took the van back to my local garage, because I wasn't convinced. Turns out that that noise is a good recording of a water-pump going! It wasn't the pulley (but, to be fair, that was from a cursory examination). I'm much happier now, knowing what the probl...

Hi, My airco belt has been taken off after the bearings on the compressor went (and I didn't use it anyway). So it's just the one belt. I haven't been able to find ANY details on the pulley itself - but I have seen references to dampened ones (but I thought that was just TD?). I haven't got in-close...

Update (thanks for the welcomes) : I got the leisure system working beautifully ... and found out my starter battery was no good either! Have re-placed both and wired it all up, and it now 'just works'. Beautiful box which fits neatly onto the air intake(?), and wires together very tidily. I'll post...

Hi, I've recently had my engine serviced, and it's been running beautifully. However I've started to get a noise from the front of the engine. My local garage identified it as a worn crankshaft pulley (CS). I have tried to get one of these, but cannot find one directly online. In answer to my query,...

Thanks, and sorry for your obvious frustration.
I now know that the Alternator does not have a D+ (or equivalent).
I had installed it without, hence my readings, and it is working fine.
It would have been good it there was a D+ as the unit would be more sensitive.
Best Regards
tim

Isn't X-20 the one I want? It's only going to be attached to a sensor, which determines the actual voltage coming from the alternator? No load. It's labelled as D+ for the unit (hangover from dynamos apparently). I think I would need to take it from between the alternator and the ignition relay - wh...

Thanks for that - I spent a while enabling Flash, but it was worth it. My model manual's not ready yet, but I'll assume the general principle ... Am I correct in reading that I can take the X-20 wire (G/R) from the alternator and tap that to take a voltage reading from the alternator output? I don't...

Ouch. Sorry. I've looked at multiple wiring diagrams, and can't make head nor tail of them with reference to real life. I was just following installation instructions, and hadn't heard of D+ before and thought someone might know. Turns out I'm looking for the voltage sense wire, which may or may not...

Sorry. I'm not quite that dumb, I'm just hoping someone can point me at the info I need. I don't know the engine compartment of a Bongo (although I had a look when a flood impact ripped off the underskirt bit, and I know where the alternator is). I have difficulty moving the driver's seat and having...

Hi, My name's tim. I'm a recent re-joiner to BongoFury, but I was a member a while back. I've had my Bongo for 10 years(ish) now (and I've used the site in the meantime when I wanted to know something) I'm introducing myself here, but the introduction is a bit long, so I'll ask the questions I have ...