llwyn celyn bach is a good site with basic facilities.its about a 10 minute walk into llanberis town centre.
http://www.campinginllanberis.com/

i would start by checking steering fluid level under drivers seat

i'll certainly not be going there again,it's the first time iv'e ever used a garage in six years owning bongo
prefer to work on van myself.the way the weather has been lately forced my hand a little bit.thanks again for the support guys.

just been out to compare teeth on abs ring and low and behold no abs ring.basically garage have fobbed me off.managed to get abs ring off old driveshaft using blowtorch and gentle tap with cold chisel.fingers crossed this will sort it out.will let you know how things go.many thanks to all for taking...

the garage has told me that when they changed driveshafts first time only one of them had the abs ring fitted. this probably explains why the abs light came on when i drove away.both shafts now have abs rings on. would the original fault still show ie do i need to get the ecu cleared,or should it ha...

do you know if its possible to change over abs rings. i didn't think the teeth may be different

took it back twice bob. garage says it must be a faulty part,but i cant see how it can be.
thanks for the reply

hi all,just had both front driveshafts replaced on
4x4 2.5 diesel.after driving about half a mile abs
light comes on and stays on.both abs rings were
on replacement shafts.can anyone shed any light
on what may be causing this and how to remedy
it.thanks,tay

lift drivers side seat up to access engine and
you should see the container in front of you
im sure it says steering fluid only on the lid

one of the pods were not as tough as you northern lot

can you put us down please dave.if we want to book a shed do we do that direct with upwood?

this ones basic but an excellent base for snowdon and close to llanberis (5 min walk)
http://www.campinginllanberis.com/www.c ... fo.php?p=2
plus you can have a campfire.

thanks for the reply i'll have a look

hi folks,after a bit of faffing about discovered a leak from rear heater matrix. just wondered if anyone has any advice on removal and re-fit.can it be done in situ by popping the top off the heater box or has it all got to come out.if it has to be a total removal do i have to get aircon de-gassed o...

thanks to dave for sorting out a fantastic weekend again.jaws still aching from all
the laughing.