Help need photo of connector under airbag

[Jolly Rogers]

Well managed to remove my steering wheel without breaking my nose but managed to inadvertantly pull the wires out from the connector for the horn I have three wires but not too sure which way they go Can some please post a photo or tell me which way they go round thanks yours rather embaressed

Jolly Rogers

[g8dhe]

Here are the diagrams and locations inside the cab area;

the WL-T is a slight variation;

and inside the cab area these are the locations;

Not quite sure why three colours but there seems to be an unused module (E1-01), which will have G/O (Green/Orange ?) and G/R (Green/Red ?) going into it, the switch will have the G/R and most likely Black as the ground wire going to it.

[Jolly Rogers]

Thanks for the reply and pictures. I still cannot work out which holes the wires go in . Here are some pictures
,maybe someone can have a look at theres and advice
Yours Jolly Rogers in the dog house

[g8dhe]

Which year are you 1995-1997 or 1997-1999

[Jolly Rogers]

Which year are you 1995-1997 or 1997-1999

1997-1999

[g8dhe]

Ah ha here you are the E1-01 connector whilst maybe only be showing with 1 wire in use is actually as below;

it has 5 receptacles on the lower and three on the upper - but obviously not always all connected ....
Trouble is yours shows 6 connectors on only a single row......
However some of the colours match up ..... R/W Red/White, R Red & G/R Green/Red
Doh ......
I guess the connector can't be seen when the wheel is in place ? But I'll have a look at ours tomorrow ... but I'm not taking the wheel off No way

[Jolly Rogers]

Don't worry you don't have to take the wheel off Just undo the 4 bolts at the back to lift off the airbag

[brorabongo]

Hope this helps....




Mines a 96 though.

I would be s*****g it reconnecting, incase it goes off

Take care.

[waycar8]

hmmn, been out and had a look at mine, mines 97 r, but...........

yellow with red stripe is the end wire
yellow with black stripe is the middle wire
green with red stripe is the other end wire thats closest to the open ports in the block


not much help i am afraid but maybe help someone in the future

[Jolly Rogers]

You guys are really great thanks


Right wish me luck.
I am going to re connect it
If I don't post back in twenty minutes............. It was great knowing you all

[Jolly Rogers]

Thanks brorabongo and Waycar8 . I owe you two big time.
by the way any one who thinks a Mazda MX6 leather steering wheel will fit
Don't even think about it

[waycar8]

so have you reconected your old steering wheel??

[Jolly Rogers]

Yes

[brorabongo]

[quote="Jolly Rogers"] Thanks brorabongo and Waycar8 . I owe you two big time.[quote]

Your welcome.

[waycar8]

so come on spill the beans..............why didnt the mx6 steering wheel fit?, airbag not campatible?