Page 2 of 4
Re: No Go Bongo.
Posted: Mon May 31, 2010 7:40 pm
by umbongocat
Solonoid

We had an issues with that this weekend, but opposite to you. Ours wouldn't stop! My partner is posting up about it later tonight. However, luckily the van was under warranty and they were great and sorted it out today

Re: No Go Bongo.
Posted: Mon May 31, 2010 8:39 pm
by dobby
mister munkey wrote:Cheers chums. This hurts.
If it is the belt, its a rare thing indeed. No idea of the added damage possibilities
Its in the hands of a Greater Power now.
Would be nice if I can get a smile back on my face before Friday - we're due to be at Debbies meet in Angelsey.

Hope its low cost and hassle free

Re: No Go Bongo.
Posted: Mon May 31, 2010 10:05 pm
by friendeedebs
dobby wrote:mister munkey wrote:Cheers chums. This hurts.
If it is the belt, its a rare thing indeed. No idea of the added damage possibilities
Its in the hands of a Greater Power now.
Would be nice if I can get a smile back on my face before Friday - we're due to be at Debbies meet in Angelsey.

Hope its low cost and hassle free

Ditto and hope you make it Friday

do you have other means of transport and a tent ?? just a thought

but really hope you get your bongo sorted

Re: No Go Bongo.
Posted: Tue Jun 01, 2010 3:48 am
by Yorkshire Puddings
Do hope you manage to get it sorted x
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 5:32 am
by TINCA TINCA
Hi Chris. Hope you will get it sorted. Afraid we have no suggestions but thought we would let you know that we are thinking of you. FINGERS CROSSED. We are in the middle of putting alternator belts on....one went. Also A SUSPECT OIL LEAK TO BE DETECTED. Bongo's are like children....they never stop causing you some grief or other.
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 6:19 pm
by mister munkey
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 6:24 pm
by dobby
Bad news and good news?
Fingers crossed. Hope it gets fixed.
See you at the bash?
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 7:02 pm
by dandemann8
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 7:03 pm
by francophile1947
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 7:17 pm
by mikeonb4c
What a bummer. But thats amazing of Max to come up all that way.

What on earth caused it, and will any damage have been done to valves etc? Hope you get it sorted OK MM, and quickly.
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 7:20 pm
by Alacrity
I am sorry to say but my first thought is the cam belt. All the symptoms, sudden stop, lumpy & sounding strange when cranking & of course no go.
I would like you to prove me wrong on this.
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 7:36 pm
by dobby
Alacrity wrote:I am sorry to say but my first thought is the cam belt. All the symptoms, sudden stop, lumpy & sounding strange when cranking & of course no go.
I would like you to prove me wrong on this.
Sorry bit confused, did you mean that the cambelt going has caused the cam to snap?
Re: No Go Bongo.
Posted: Tue Jun 01, 2010 8:21 pm
by Alacrity
Sorry - didn't read thread all the way through, I will shut up now.

Re: No Go Bongo.
Posted: Tue Jun 01, 2010 8:56 pm
by mister munkey
Possibly one of those questions that will never be answered John.
New complete genuine Mazda fully built up head in October '07. Probably done around 45,000 miles since. Regular oil/filter changes but usually driven with a "sense of purpose" & most weekly use has been relatively short - 6 mile each way - commmuting . . . Cold engine being driven hard on a fairly hilly rat-run, can't have helped.
(Even so, it could be sand from Blackpool on Sunday - That stuff got everywhere. Might get my legal department to start proceedings against Blackpool Council.)
On the most part I think its just down to bad luck but will see if my Chief Engineer can come up with any ideas when doing the rebuild.
Despite the fact that this has spiraled from a ten quid solenoid to a fairly hefty labour charge, the help I've had from The Gang has made me feel a lot better about the whole sorry mess. I'm so glad I never bought that Elgrand.
Thanks again you lot.

Re: No Go Bongo.
Posted: Tue Jun 01, 2010 9:15 pm
by Bob