Bongo Fury

Posted: **Mon May 23, 2016 8:25 am**

Tessie wrote: the only problem I had was that one of the underneath bolt holes on the side plates didn't match up. However, this could have been my fault as I did a bit of banging and crowbarring before reading how others had done the job so I could have bent it out of shape. A little elongating of the hole soon solved the problem.

Had that exact same problem too, but yes there was a bit prying & levering getting done. just elongated the holes to persuade it to fit back on. had to make the same notches too.
I reckon if doing it again I could knock off 2 hours.

Posted: **Mon May 23, 2016 8:00 pm**

nth wrote: Had that exact same problem too, but yes there was a bit prying & levering getting done. just elongated the holes to persuade it to fit back on. had to make the same notches too.
I reckon if doing it again I could knock off 2 hours.

Hopefully you won't have to do it again, not on yours anyway

, Maybe you are offering to do the job for other Bongo owners

Posted: **Mon May 23, 2016 8:04 pm**

someone i know is doin one tomorrow,

Posted: **Tue May 24, 2016 1:11 pm**

Good luck to someone you know and the 'million' spot welds you, sorry, they will be drilling out

Bongo Fury

Front crossmember

Re: Front crossmember

Re: Front crossmember

Re: Front crossmember

Re: Front crossmember