Bongo Fury

oh lol. im a bit of a dipstick. lols

Gaza69 wrote:oh lol. im a bit of a dipstick. lols

No you ain't, i was being just aving a romp...

Ask away, all will become apparent!

There is a factsheet in the members area on fitting remote central locking that should help too.

Gaza69 wrote:oh lol. im a bit of a dipstick. lols

http://www.rclick.co.uk/product_info.ph ... cts_id=242

Just order one when you order your keyless kit

csmcqueen wrote:

Gaza69 wrote:oh lol. im a bit of a dipstick. lols

http://www.rclick.co.uk/product_info.ph ... cts_id=242

Just order one when you order your keyless kit

Thankyou. lol

Think i'l order soon but wait a little while for the weather to warm up a bit before i fit it.

Cheers all

Probably best to start a new topic for that

ok, sorry.

Did anyone get the keyblanks for the remote, which keyblank is needed?
Cheers
James

Rhinoman wrote:Did anyone get the keyblanks for the remote, which keyblank is needed?
Cheers
James

If its from Rightclick I got the MA20's and work fine - Link to other post

Scott, I've got the same remote kit as you have pictured, where is this blue/black wire on the Bongo? I,m sure it muist be right in front of me, but I'm blowed if I can spot it.
Regards
John

BONGO JAC wrote:Scott, I've got the same remote kit as you have pictured, where is this blue/black wire on the Bongo? I,m sure it muist be right in front of me, but I'm blowed if I can spot it.
Regards
John

The black/blue is the permanent live connected to the original central locking switch, I think I picked it up by the elec window switch (would check it with a meter just incase I mistook the colour

Hi,

I am trying to fit the rclick brain unit and don't have a clue where to find the open and close wires, I'm finding the instructions they sent for the Bongo to be useless and i'm not doing a lot else than blowing fuses!

Can anyone tell me where the 'open' and 'close' wires are for the central locking unit please. My van is 1996 'N' and the instructions say it should be a light green and a grey wire.

I can't see these anywhere in the A pillar or foot well.

Also what do I connect the 2 wires to from the actuator? I think I connect the blue wire to a 12v positive but don't understand where I find a 12v negative for the green



Thank you!

If your a member of the club (rather than just the forum) then the fact sheet will possibly help http://www.igmaynard.co.uk/bongo/member ... ocking.pdf

Hi,

Yes I did read that several times. It just says connect the wiring to the existing central locking wiring but not any more specific than that, not being familiar with the electrics I don't know which to connect and the rclick manual doesn't seem to be much help.

You don't intercept any wiring other than to pick up the +12v and earth, you fit one new solenoid to operate the existing mechanical link on the drivers door, and that solenoid is driven by the new unit and that's all.