Bongo Fury

Hi there, new to this bongoing but I need some urgent advice please on alloys to fit a bongo please help ! been offered-
set of alloys from a MX5 (MK3) with yokohamer tyres size 205/50/R16 will these wheels fit my 1999 bongo. any body reading this can help with alloys they have please contact me
many thanks TEZ

Welcome to the forum

From my limitted knowledge if they are 5 stud they should fit but what are the lodad ratings of the tyres?

a more experienced person will answer


however do you realy want to put your mobile on here for anyone to see?

Cheers Rob took your advice on mobile. THANKS
answer to your question on load etc this is the info I have-
Aspect ratio- 50
Load index- 87
Speed rating V 149mph
thanks TEZ

the load rating is very low for a bongo they need to be at least 96 for the rear and 92 front

This site gives the MX5 dimensions for alloys. It doesn't look like they'll fit from this info.


The Bongo is 5 stud, PCD of 114.3 , and centre bore of 67.1mm.

SD

Those tyres are no use at all - load index is not high enough. It should be a minimum of 92 front and 96 rear. They're also 7.5% too small, so your speedo would be well out.
Have a look at this site http://www.nice-wheels.co.uk/ - you can check which wheels will fit and what size tyres you need.

there you go I had everything but the central bore which is too small.

they wont fit and the load rating of the tyres is too weak

stilldesperate wrote:This site gives the MX5 dimensions for alloys. It doesn't look like they'll fit from this info.


The Bongo is 5 stud, PCD of 114.3 , and centre bore of 67.1mm.

SD

The new MX5 wheels are 5 stud and have the same fitting as the Bongo - won't be many of them on Ebay yet though

THANKS GUYS MUCH APPRECIATED INFO, AND STUNNINGLY QUICK !!.
WELL BACK TO THE DRAWING BOARD I GO.
CHEERS TEZ.

If you're after second-hand, one to look out for is the Mitsubishi Pinnin alloys / tyres.
I run them with 215/65 x 16". They're basically imported Shoguns, so load-wise, they're fine.

I got 4 alloys, plus a steel spare, with good tyres, for under £250.

SD

Or mitsubishi outlander (mk1) alloys will fit too

Hi, Sorry to bump this thread back up, but I didn't fully understand the answer.

Do the MX5 5 stud alloys fit the Bongo or not??

I picked up a set from eBay from a 2006 MX5, I was going to change the tyres from my Bongo and put them on the MX5 alloys.

Thanks in advance for any replies!!

You will need to ensure that the offset is the same on your existing wheels and the new alloys i.e. the distance from the face of the mounting plate to the centre of the tyre. It varies from car to car and if you don't get it right the wheel won't be in the same position relative to the wheel arch

See here

sidyboy75 wrote:Hi, Sorry to bump this thread back up, but I didn't fully understand the answer.

Do the MX5 5 stud alloys fit the Bongo or not??

I picked up a set from eBay from a 2006 MX5, I was going to change the tyres from my Bongo and put them on the MX5 alloys.

Thanks in advance for any replies!!

Make : Mazda Model : MX5 5 Stud Year : 05> PCD : 5x114 Offset : 35 to 45 Bore : 67.1 Fittings :
These will fit.

Thanks for the replies!!

Just wondering whether the alloys will be strong enough though?