Bongo Fury

having touble with the washer jets not working
pulled the pipes off and water comes through
tried clearing the nozzles with a pin but no
want to take the nozzles off to clean but can some one tell me the best way to get the nozzles off do i just need some long nose pliers to squeeze the bottom of the nozzles

They do appear http://www.lushprojects.com/bongopartsm ... mgno=.html to be just push fits ....

i looked at that and doesnt show how they fit
i have tried pushing them out but they aint shifting
had a look and does look like they are clipped in and i just cant shift them
anyone removed theirs

Well there aren't any screws shown and I seem to remember Kirsty (missfixit70) referring to them recently as being pop in ones in a recent thread.

Yup just found it, perhaps gabby has the answer as well http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=41082

theres no screws it looks like the have a sort of clip holding them in, which would mean they just clip in but it looks like i need to press the clip either side to get them out but the hole is to small for my pliers think i will have to try and borrow a pair of longer long nose pliers

well i finaly got them out there are two clips that you have to push in to get them out
only thing is after cleaning out the nozzles out i managed to lose one of the jets when testing (dont ask it was my own stupid fault)
cant beleive they cost £18.95 each i have ordered some chrome ones from ebay for about £5 for the pair .