Bongo Fury

Hi guys,

I am planning on fitting a pedestal table (animal skim board ) behind the front seats so need to make hole in the floor to place bottom hole plate.
My questions are..........

1 has anyone else fitted one of these ?
2 what would be the best/easiest way to cut the hole ?
3 Is there anything that runs flush to the floor pan that i may cut into !!!!!?

Cheers chaps and chapesses

Yep...no problem....big hole cutter...or...I used a fine jigsaw

haydn callow wrote:Yep...no problem....big hole cutter...or...I used a fine jigsaw

cool. Cheers haydn. I have tried to look but its raining im guessing there is nothing that could get chopped if i use a hole cutter ?

You should be ok if you're careful, this may help from the waxoil thread

bongobaz wrote:

It definitely requires a careful look underneath, as there is plenty you could hit with a drill if you put it in the wrong place. Have you got a flat plywood floor, or are you planning to put it onto the carpet. If the latter, I would suggest a bit of ply put under the carpet so that it beds down on a decent surface. From memory, I think the base is recessed into the floor by about 50mm.