Bongo Fury

Hi one of the bulbs isnt working behind my blind switch on the front dash. How do i get the switch off and get to the bulb please?

thanks

marc

Thanks Steve but how do i get at the pesky little bulb please?

Any further help on this one please?

I got a feeling the bulbs on a brown rubber stalk with two thin wires running to the dash circuit on the switch PCB..?

You may find a clean & a jiggle might get the bulb to work again!!?

Thanks but how do i get at it - do i just prize it off?

SPARKYSSS wrote:Thanks Steve but how do i get at the pesky little bulb please?

Sorry marc, i haven't the foggiest mate, i just did a search, sorry.

They normally just prise out there are a couple of press in barbs top and bottom, here's a rather grotty picture but best I can do at this time of night!

SPARKYSSS wrote:Thanks but how do i get at it - do i just prize it off?

Four clips holding the back where it connects to the loom... Thin driver in the side & gently prize out, the rest should follow... (Two clips on each side, staggered/off set so you can't re assemble the wrong way round!)

I suggest you do t on a tray so you don't lose anything out of the switch!

I would also take the opportunity to clean the contacts on the switch while in there... they sometimes mung up!??

g8dhe wrote:They normally just prise out there are a couple of press in barbs top and bottom, here's a rather grotty picture but best I can do at this time of night!

Thats a fog light switch or something from the top bank!?

Excellent thanks a lot for that - i will give it a go

You were right Jaylee - the bulb is in a long rubber thin tube with 2 thikn wires going into the switch. I have given it a clean and a jiggle and still no good - so going to have replace the bulb.

Thanks a lot for your help - another little niggle sorted

marc