Bongo Fury

Hi,
Well out of comfort zone, but gained access to printed circuit board. Slight worry is that the instructions and factsheet clearly show the blue going to a terminal marked T-U......but mine is marked F-U, is this a mistake on the instructions...anyone seen this? or am I just na super-pedant!!!?

Ha! sorted there was dirt over the labelling, wiped it off and hey presto! Made difficult as the importer had wired the low coolant warning light into the dial unit, and the feed wire was so tight that I couldn't get to the back properly!...scraped knuckles on mt lilywhite hands!

Glad you got it sorted DD Keep those screws tight to maintain a good connection