Page 1 of 1

No fuel at my filter.......

Posted: Thu Jul 21, 2011 3:34 pm
by PeterP
Any ideas chaps, I broke down today, looks like I ran out of fuel.....but....
there is plenty of fuel in the tank, but cant get any to the fuel filter.
Does the sender unit have a pump in it?

Re: No fuel at my filter.......

Posted: Thu Jul 21, 2011 3:52 pm
by missfixit70
No lift pump, could be a fuel hose has split (they are supposed to be replaced every 4 years according to the service schedule) or the strainer on the pick up has become blocked, or the tank breather isn't working right. Here's the schematic (assuming you've got a diesel) -
http://lushprojects.com/bongopartsmk2/c ... mgno=.html
or this one if you're petrol -
http://lushprojects.com/bongopartsmk2/c ... mgno=.html
Personally I'd try drawing through the filter from a know clean source (ie fuel can with a bit of hose connected to the inlet side of filter) to check the pump is working & filter & banjo strainer are clear . Check the pump, hoses & pipework for leaks.

Re: No fuel at my filter.......

Posted: Thu Jul 21, 2011 4:52 pm
by PeterP
all sorted....
I pulled a vac on the hose from the tank to the filter (filter end) and all I could pull was air.
Traced it to a split hose.

Replaced the rubber hose and were on the road again.
Thanks for the link to the drawings.

Re: No fuel at my filter.......

Posted: Thu Jul 21, 2011 4:59 pm
by missfixit70
Result :D which hose was split? - Hose diagrams here
http://lushprojects.com/bongopartsmk2/c ... mgno=.html
or

http://lushprojects.com/bongopartsmk2/c ... mgno=.html
may help someone in the future with similar issues. Also would probably be worth replacing the rest of the hoses too as they'll probably all be the same age, not expensive to do either - http://www.igmaynard.co.uk/bongo/forum/ ... 0&start=15