Page 1 of 1
HELP HELP HELP
Posted: Sat Aug 13, 2011 5:04 pm
by dandemann8
As it was a nice afternoon I decided to change the oil and oil filter with my new Pela pump but stupidly I've pumped out the ATF by mistake
Now I haven't a clue what to do

what do I need and how do I put this right
I'm now going to crawl in a corner and cry

and wait for the answer please

Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 5:10 pm
by westonwarrior
if the pella is clean put the atf back
or take advantage and get some new atf and replace it,
Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 5:13 pm
by missfixit70
While you've pumped it out, you may as well drop the gearbox sump & clean the filter

-
http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=30096 however much you've taken out, you need to put back in, Dexron III, could be anything between 4.5 & 7 litres. Refill down the
DIPSTICK hole
If you can't get out to get any ATF fluid, then if it's clean, you may be able to reuse, I'd at least filter it, but it'd be better to get new in there.
Too slow

Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 5:17 pm
by westonwarrior
I may have posted first but spent until now looking up the type of atf to use
Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 5:47 pm
by dandemann8
As the ATF was new I've just replaced it, do I need to do anything now

Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 7:04 pm
by wonkanoby
would still clean grime and gunk if you can from sump if you did not before
Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 7:12 pm
by missfixit70
dandemann8 wrote:As the ATF was new I've just replaced it, do I need to do anything now

Put a label on the dipstick saying "gearbox oil"?
Check the level cold it should be above the top mark, then check it as the engine warms up, range through the gears to make sure it's everywhere it should be & check again.
Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 7:19 pm
by dandemann8
missfixit70 wrote:dandemann8 wrote:As the ATF was new I've just replaced it, do I need to do anything now

Put a label on the dipstick saying "gearbox oil"?
Check the level cold it should be above the top mark, then check it as the engine warms up, range through the gears to make sure it's everywhere it should be & check again.
Yet again this forum and its members come to the rescue to help a wanna be mechanic out of deep do do
Thank you

Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 7:21 pm
by missfixit70
Just be careful where you stick your pump in future

Re: HELP HELP HELP
Posted: Sat Aug 13, 2011 7:44 pm
by dandemann8
Re: HELP HELP HELP
Posted: Sun Aug 14, 2011 12:24 am
by The Great Pretender
Re: HELP HELP HELP
Posted: Sun Aug 14, 2011 1:16 am
by cheffy34
my engine dipstick is yellow on the end

Re: HELP HELP HELP
Posted: Sun Aug 14, 2011 7:32 am
by alant54
Re: HELP HELP HELP
Posted: Sun Aug 14, 2011 1:11 pm
by dandemann8
Re: HELP HELP HELP
Posted: Sun Aug 14, 2011 11:58 pm
by The Great Pretender
Nope................Believe BP got that one while deep drilling........