Bongo Fury

iv just got a spoiler from eBay and it's got the stop light... Does anyone know if theres the wiring loom for it in the back or will I have to drill it and make one?

Had half an eye on that as well..do they fit 'Mk1' Bongos?

Derek

Mine is a 96 and it fits a treat. We have just done it I think we got ours from bongo bits on ebay x

Hi,
Just got a spoiler for mine too. There are few threads about but thought I'd bring it up again in case of any last minute tips.
I've got some M6 bolts which are too long (25mm) so think I prob need some 15mm long.
I was planning on using the method of imprinting the bolts on some tape described elsewhere to get the position.
I take it also need to drill a wire hole in the tailgate behind the spoiler and (somehow) feed the wire(s) through the rubber tube in to the body and down in to the tail light cluster ?
Any comments or advice before I start ?
Cheers.

I didn't bother to drill, I just hid the wires behind the rubber seal and fed it through to the light cluster.

Thanks, didn't want to drill any more than needed

We did it with no drilling