Page 1 of 1
Cup holder to replace ashtray
Posted: Mon Jan 27, 2020 2:14 pm
by BongoBeeman
Just got my bongo amd a cheap mod which would be useful is to replace the ashtray with a cup holder. I know MX-5 fits but they seem pricey at £40, and have seen 3d printed on ebay for 14.
Anyone got one got one surplus to requirement, ot any exeprience of either the mx-5 replacement or ebay 3d printed??
Re: Cup holder to replace ashtray
Posted: Mon Jan 27, 2020 2:29 pm
by Bob
These flasks are good and fit in the existing cup holders.
Keep your drinks warm for a good while.
https://www.alloutdoor.co.uk/equipment/ ... 21EALw_wcB
Other outdoors shops and Amazon do them.
Re: Cup holder to replace ashtray
Posted: Mon Jan 27, 2020 9:52 pm
by BongoBeeman
Re: Cup holder to replace ashtray
Posted: Mon Jan 27, 2020 10:09 pm
by Bob
You're most welcome.
If you cycle they fit the bottle cage on your bike, too.
Just make sure you leave about 1/2" space below the screw thread when you fill them, and don't be tempted to fill with boiling water and shake. The top will blow off.
