Re: EGR Blanking
Posted: Thu Oct 22, 2020 11:24 am
Is there any chance you have a dxf file you can share for the egr blanking plates. I’m in New Zealand and have access to a laser cutter.
Bongo Fury
A forum for Bongo fans and owners
https://www.igmaynard.co.uk/bongo/forum/
EGR Blanking
https://www.igmaynard.co.uk/bongo/forum/viewtopic.php?t=77516
Page 2 of 2
Re: EGR Blanking
Posted: Fri Oct 23, 2020 9:33 am
I guess you could make a pattern with some thick paper and a crayon?
Re: EGR Blanking
Posted: Fri Oct 23, 2020 12:08 pm
There is a gasket between the EGR joint. You could draw around it.
Re: EGR Blanking
Posted: Thu Nov 05, 2020 5:51 pm
Yeah that’s plan B. Was just being a bit lazy
Re: EGR Blanking
Posted: Sat Apr 20, 2024 11:16 am
Hi Robrobhho123 wrote: ↑Thu Sep 10, 2020 10:58 am Hi All
After reading on here about EGR blanking and speaking to my dad that used to blank them off on race cars as it's loss of power etc and really not
needed but obviously has to be done for emissions wise. I have opted to Blank it off to stop all the gunk getting into the inlet to hopefully prevent any issues later down the line. So my plan is to take the pipe of this weekend and draw up the blanks then cnc machine them, My question is does anyone want any at the same time as I might as well make a few at the same time.
Rob
Do you have any blankig plates made up & looking for a new home?