I have a van I imported to the USA , and have been fighting the air con since day one.i repaired a leak on a rear line that was going into the rear matrix it is the smaller line with the 10mm bolt , the issue is the thread is stripped , on the matrix side , I am either going to tap it it out to a 1 ...

fantastic with the schematic , cheers

It was The only one that shipped to the states , it is the long screw coming down from the top in fact I think the shipping cost more than the
alarm

I just drove around 1800 miles , I have a coolant alarm , if I'm driving on a motorway I can drive 400 miles non stop and no issue , if I turn to get petrol as soon as I get in the forecourt and do a u turn the alarm beeps for a 2nd then stops , I get worried and top it up , and off I go again , the ...

did you figure this out I see the nut and bolt just could not undo the clip or see how to undo it

on the rear air con lines I see a leak at the 90 degree bend there is a plastic clip that holds 3 lines I undid the nut bolt. but how does the clip come apart so I can remove one of the lines to repair the pinhole the clips I'm just unsure

have looked high and low how to remove the rear matrix as mine is undercoated its 1 95 2.5 d 4x4. not sure how to pull out is there any notes anywhere how to remove

i too have the same leak how did you end up repairing