Removal it is then, anything with the word dealer in it is going to be expensive
I thought there might be a pattern one but could not find it
Cheers Guys

where would i get a new one from?
cheers

Where can i buy a new rear heater matrix from?
Mine is leaking
Cheers

When you bleed the system you should never let it run long enough to boil the coolant, you shouldnt get clouds of steam and huge eruptions from the bleed pipe

you can get them from bongo bits
about £116

Hi guys
The reason that they say not to use copper pipe for these sort of things is due to the fact that copper is soft and prolonged vibration will wear thru it!

Have done the EGR mod tonight and as i pulled the little black pipe off to put a bolt in it, it shattered into little bits, went and got some new pipe and all was well
took out for a test drive and hey presto no more smoke :D
after checking all the other little black pipes under the drivers seat ...

by using the bleed valve the only difference in the bleeding process would be that the bongo would not be spitting out hot water, only air

also dont forget that you would not leave it on the engine permanantly, just while your bleeding it

i didnt know there were 2 grades of waxoil

question answered

cheers

Just wondered what you bongolians use for underseal, i know about wax oil for the nooks and crannies, but what about the wheel arches and big areas underneath
ps i dont like that black tar like stuff, ive found in the past it does more harm than good

cant see them on website, have you got one from them, if so how much?

cheers

Does anyone know where i can get a new rear door seal from?

cheers

ive just come back from italy and we used the bongo speedo for miles and the satnav for kph

when i wrote "The idea was just to leave the bleed valve on the engine until it warms up whilst following the proper mazda method, your probably find you get that last bit of air out "

i ment put it on the proper bleed pipe under the passanger seat

when i write stuff i just assume people know what ...

When you fill the system with cold coolant your bound to get a bit of air her and there, same as in a domestic system, but when you heat the water it expands and usually you get a little burble or two.

The idea was just to leave the bleed valve on the engine until it warms up whilst following the ...