Hazard lights switch

missfixit70 · Post by **missfixit70** » Tue Feb 12, 2008 7:38 pm

aitch wrote:mine dosen't glow in the dark (i've checked) and it also dosn't have a bulb fitted where did mine go wrong?

I thought mine didn't, until SSS pointed out that it did thanks to the schematics, the bulb holder is recessed into the side of the switch & a bit of a bugger to get out

Post by **aitch** » Tue Feb 12, 2008 7:53 pm

are those bulbs soldered into place? or push fit?

missfixit70 · Post by **missfixit70** » Tue Feb 12, 2008 8:26 pm

long legged 3mm wire filament type bulb that is pushed into the holder & the legs are then bent round into place to hold it in. The holder itself is just a twist fit. check out the link to the other thread I posted above, it tells you in there which bulbs to get & where from

It's an easier job than the door lock

Post by **aitch** » Tue Feb 12, 2008 9:06 pm

thanks for that one kirsty will try and get the switch out when I get fed up with the door lock problem later this week (hopefully)

lizard · Post by **lizard** » Tue Feb 12, 2008 10:18 pm

Never noticed it before, been out to look and no light showing. Will have to take it apart now to see if it has a lamp in it, hate things that dont work

bigdaddycain · Post by **bigdaddycain** » Tue Feb 12, 2008 10:23 pm

Me too... the glovebox light was on my list of things to fix,when i did get round to doing it, i realized there wasn't one....

( glovebox light that is...not the glovebox...)

maxheadroom · Post by **maxheadroom** » Wed Feb 13, 2008 4:11 am