Is this a speedo chip or part of the loom???

[Triple/R]

well it says GA5R on the dial so that'll do nicely

[falcoron]

anyone know which would fit my 2.5 diesel 1995?

[Triple/R]

anyone know which would fit my 2.5 diesel 1995?

the same one mate keep an eye out on ebay or local scrappy.

[mister munkey]

MX6 is a GA5R too.

I'm starting to collect them from my other forum.

Might have a couple spare soon . . . .

[falcoron]

anyone know which would fit my 2.5 diesel 1995?

the same one mate keep an eye out on ebay or local scrappy.

does it just pop straight in. I can do that ok just had mine out to fit a mason. but mine reads mph but trip is kms
is clocks exactly the same configuration? have seen some on ebay with temp gauge on oposite side of facia

[dave_aber]

I got a 626 instrument unit, removed the GA5R speedo from it, and it just dropped in to the Bongo instrument cluster. Reads Miles / MPH very accurately compared to my GPS. You can't fit the whole 626 binnacle in though.

[BONGODADDY]

Hi Ray,

I have just purchased one of those speedos (Just waiting for it to arrive) pretty much the same situ as you, i have a chip as well, maybe i could bring it along to Tackeroo2 and you could shout instructions at me as to how best to tackle the job
Or i could make the tea

See you soon mate
Paul.

[maxheadroom]

Ten minute job.....

http://www.igmaynard.co.uk/bongo/forum/ ... it=top+tip

[Triple/R]

Hi Ray,

I have just purchased one of those speedos (Just waiting for it to arrive) pretty much the same situ as you, i have a chip as well, maybe i could bring it along to Tackeroo2 and you could shout instructions at me as to how best to tackle the job
Or i could make the tea

See you soon mate
Paul.

No probs Paul i'm sure we can sort it~did you get the clear plastic front that covers the dials cus sometimes the trip button (on your new one) is thicker & wont go through the hole so you have to make hole bigger with a slightly bigger drill bit or summat similar.

[maxheadroom]

No probs Paul i'm sure we can sort it~did you get the clear plastic front that covers the dials cus sometimes the trip button (on your new one) is thicker & wont go through the hole so you have to make hole bigger with a slightly bigger drill bit or summat similar.

or just swap the Bongo trip button over it's only one screw if I remember right

[Triple/R]

No probs Paul i'm sure we can sort it~did you get the clear plastic front that covers the dials cus sometimes the trip button (on your new one) is thicker & wont go through the hole so you have to make hole bigger with a slightly bigger drill bit or summat similar.

or just swap the Bongo trip button over it's only one screw if I remember right

Nice one did'nt know that

[Triple/R]

Ten minute job.....

http://www.igmaynard.co.uk/bongo/forum/ ... it=top+tip

It's thanks to you Max for spotting this in the first place that people like me (useless with electrics) can do job's like these~but will probably take me more than ten minutes~but whats the rush as long as result is same

[BONGODADDY]

Hi Ray / Max,

Sounds like you both know what you are doing so i will bring the whole thing to Tackeroo as it is the complete cluster and when i get back from fetching the wood it will all be done !!

Paul.