power switch for blinds

[philljenk]

I am trying to separate the power connector from the rear drivers side blind switch. Is there a trick to do this as it seems very reluctant to separate.
I would hate to damage it by forcing. Any help would be appreciated
thanks

[g8dhe]

Not looked at that particular switch, but yes normally there are clips that need depressing or sometimes lifting to allow release of the loom cables.

[philljenk]

thanks for that, thought it might be something like that, problem is finding it. Shall have another close exam of it

[munroman]

Not looked at that particular switch, but yes normally there are clips that need depressing or sometimes lifting to allow release of the loom cables.

I find that a short moan about the economy and the price of fuel is usually enough to do the trick! Happy to Help!

[g8dhe]

Sounds like you could give Marvin some tips

[philljenk]

cant find any obvious kind of clip on it. There is a white bit and brown bit with the connector pins on the back of the switch, I need to reposition the switch on a side conversion. Any other thoughts would be appreciated. thanks

[jaylee]

From memory, they just pull apart to disconnect the switch from the loom connector....

I did a little modding over the sliding door a while back, & had the rear panel out too!

I would not be too difficult to extend the loom & reposition the blind switch...

[philljenk]

Success...very simple little lug on the white connector, press down and hey presto they are separated.