Handbrake Cable connection plate

[spad112]

Hi everybody,I don't normally post much on the forum but here goes.

While I was getting handbrake adjusted the plate which connects the single cable from the handbrake to the two cables feeding the rear brakeshoes broke,rusted I think.
Where can I get a new one or do I have to obtain one from a bongo being broken up ?

Thanks

[rita]

Hi everybody,I don't normally post much on the forum but here goes.

While I was getting handbrake adjusted the plate which connects the single cable from the handbrake to the two cables feeding the rear brakeshoes broke,rusted I think.
Where can I get a new one or do I have to obtain one from a bongo being broken up ?

Thanks

Hi you could try here........http://www.mazdabongo.com/display.products.php?pId=401

[spad112]

Hi
Thanks for the reply.The connecting bracket could be part of the single cable.But can't see it in the picture as its too small on the end of the cable.
May need to telephone and ask the question

Cheers

[helen&tony]

Hi
Spad...
Er...you're not a fan of French WW1 biplanes by any chance???
Cheers
Helen

[rita]

Hi
Thanks for the reply.The connecting bracket could be part of the single cable.But can't see it in the picture as its too small on the end of the cable.
May need to telephone and ask the question

Cheers

Hi this might show you it better......http://www.lushprojects.com/bongopartsm ... mgno=.html
44-150 is the cable
You could also try your local motor factors,you might be able to get a compatible Uni Part or QH cable for about £15.00.
Take your old cable with you...
Cheers