Bongo Fury

Anyone know a source of pipe 20-310 that goes from the exhust manifold to the EGR valve? Looked at ava lesuire, Bongo Fury shop etc can't find one. Even searching whole of google with part number only has one result, the lushprojects engine manual.

I have a big hole in mine where it's looks like it's been weleded in the past. It makes a lot of noise and seems to be loosing power.

I bought a set of plates to close of the EGR but they only blank it on the drivers side (inlet manifold) so it wont help with my hole.

My other thought is trying to find a large plumbing type endcap that will screw onto the exhaust manifold instead of the EGR pipe. I'm thinking it would need to be the same metal or differing expansion / contraction rates would be a problem?

Anyone else had this pipe go?

I've seen them go around the weld where it meets inlet elbow, just clean it up and get it re-welded?
Julian

the pipe you mention is 22mm od, so a temp repair with a standard fitting should be easy if you go down that route,
if you blank everything off,dont forget about the rocker/crankcase breather that loops into this pipe at the rear of the head.

I have one spare pm me

Northern Bongolow wrote:the pipe you mention is 22mm od, so a temp repair with a standard fitting should be easy if you go down that route,
if you blank everything off,dont forget about the rocker/crankcase breather that loops into this pipe at the rear of the head.

thanks kirsty----------im talking out of my pipe again . the rocker breather of course goes into the air/turbo pipe next to the egr pipe. glad your keeping an eye on things .

Thanks for all your replies.

I think I'm going to try getting it welded.