Page 1 of 1

Gas strut spec

Posted: Tue May 16, 2017 1:57 pm
by davidf
Does anyone know the correct spec for the gas struts to lift the Auto FreeTop roof - ie what figure should they be pressurised to? Recently replaced mine but have been told the roof is slow to rise.

thanks

Re: Gas strut spec

Posted: Tue May 16, 2017 2:29 pm
by Bob
Are you running the engine as you raise the roof?

It takes a fair bit of power, and generaly isn't fast. 8)

Re: Gas strut spec

Posted: Wed May 17, 2017 12:20 pm
by g8dhe
Mine with new gas struts takes about 25 seconds https://youtu.be/NOdxmvxyJco

Re: Gas strut spec

Posted: Thu May 18, 2017 8:16 am
by cmm303
If you've got new gas struts (presumably matched to the original part number) and the roof is still struggling it is probably another problem. The running gear can clog and seize. The motor wiring connections can develop resistance and drop volts. The motors themselves can lose power.
Assuming you have the engine is running, I'd start with checking that the lifting mechanism is clean and runners run freely.

Re: Gas strut spec

Posted: Fri May 19, 2017 5:21 pm
by davidf
Thanks everyone. I've timed the roof and it takes about 25 seconds with the engine running, so sounds as though I was worrying unnecessarily..