4 of the rocker arms on my 2.5 diesel bongo are begining to wear, where can I get some new ones from ?
thanks
Rob
rocker arms
Moderators: Doone, westonwarrior
-
robbie c
-
francophile1947
- Supreme Being
- Posts: 11354
- Joined: Mon Dec 18, 2006 6:15 pm
- Location: Norwich
Re: rocker arms
Welcome to the site
It would help if we knew where you were - see http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=29471
Have a look at the Home page here http://www.igmaynard.co.uk/bongo/bongo.htm - several dealers on there
It would help if we knew where you were - see http://www.igmaynard.co.uk/bongo/forum/ ... =3&t=29471
Have a look at the Home page here http://www.igmaynard.co.uk/bongo/bongo.htm - several dealers on there
John
(Evidence that intelligent life exists in the universe, is that it hasn't tried to contact us)
(Evidence that intelligent life exists in the universe, is that it hasn't tried to contact us)
- dandywarhol
- Supreme Being
- Posts: 5446
- Joined: Mon Dec 19, 2005 10:18 pm
- Location: Edinburgh
Re: rocker arms
Before you fit new ones - find out why the old ones wore and why only 4 of them..............
Whale oil beef hooked
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
Renault Lunar Telstar
Yamaha TD1C 250, Merc SLK200, KTM Duke 690
- gmaczbongo
- Bongolier
- Posts: 345
- Joined: Mon Dec 14, 2009 6:31 pm
- Location: Fae Dundee
Re: rocker arms
What do you mean by beginning to wear?
Need more info.
Need more info.
-
robbie c
Re: rocker arms
the van was purchased with the engine running very poorly.
had a look and its a bit more serious, the ball joints that the rockers sit in are badly worn. It looks as if the y are the wrong size thread. That however does not change the fact that unless I helicoil the head it will be scrap.
so a dilema, throw a "recon" engine in or sort this one out ?
had a look and its a bit more serious, the ball joints that the rockers sit in are badly worn. It looks as if the y are the wrong size thread. That however does not change the fact that unless I helicoil the head it will be scrap.
so a dilema, throw a "recon" engine in or sort this one out ?




